Dee Zee DZ16223 - Manual (Page 14)

Once the rear inner bolt is tightened, tighten the bolts connecting the rear brace to the
mounting bracket using a 13mm socket/wrench.
The plastic panel that was removed in Step 9 must be modified to make room for the brace
before it can be reinstalled. Use tin snips or aviation snips to cut a notch.
Measure form the edge as shown below. The start of the cut out will be at 6 -3/4".
The notch needs to be 1/2" to 3/4" wide and extend to the second rib in the panel.
18
19
TIGHTEN BOLTS
HERE WITH
DZ 16223 12 OF 15 8/9/2013