Dee Zee DZ370203 - Manual

Page 1 of 3 8/20/08 (DP)
1 Driver/Left Sidebar 14 12mm ID x 24.1mm OD x 2.1mm Flat Washers
1 Passenger/Right Sidebar 10 12mm Lock Washers
1 Driver/Left Front Frame Mounting Bracket 8 12mm Hex Nuts
1 Passenger/Right Front Frame Mounting Bracket 4 10mm x 35mm Hex Bolts
1 Driver/Left Front Sidebar Mounting Bracket 8 10mm ID x 21mm OD x 1.7mm Flat Washers
1 Passenger/Right Front Sidebar Mounting Bracket 4 10mm Lock Washers
1 Driver/Left Rear Sidebar Mounting Bracket 4 10mm Hex Nuts
1 Passenger/Right Rear Sidebar Mounting Bracket 8 8mm x 25mm Hex Bolts
2 Support Bracket Tabs (fits L-Front & R-Rear) 8 8mm x 22mm OD x 1.5mm Flat Washers
2 Support Bracket Tabs (fits R-Front & L-Rear) 8 8mm Lock Washers
2 12mm Nut Plates 4 6mm x 35mm Hex Bolts
2 12mm x 35mm Short Bolt Plates 8 6mm ID x 18mm OD x 1.6mm Flat Washers
2 12mm x 95mm Long Bolt Plates 4 6mm Nylock Nuts
6 12mm x 35mm Hex Bolts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. DO NOT ATTEMPT
INSTALLATION ALONE; PERSONAL INJURY OR DAMAGE TO THE VEHICLE MAY
RESULT. DRILLING IS REQUIRED
2. Starting at the driver side front, install the 12mm x 35mm Short Bolt Plate in the location
pictured in Figure 1A. Next, insert the 12mm Nut Plate into the hole in the underside of the
vehicle pictured in Figure 1B. Locate the driver side Front Frame Bracket and hang it from the
previously installed Nut and Bolt Plates using (1) 12mm x 35mm Bolt, (2) 12mm Lock
Washers, (2) 12mm Flat Washers and (1) 12mm Hex Nut, (Figure 2). Do not tighten hardware
at this time.
INSTALLATION INSTRUCTIONS
SIDEBAR
09 DODGE JOURNEY
PART NUMBER DZ 37020x
Rear
Mounting
Bracket
Front &
Rear
Support
Brackets
Front
Frame
Bracket
Front
Mounting
Bracket
Front
Frame
Bracket
Front
Mounting
Bracket
Rear
Mounting
Bracket
Rear Bolt Plate
(long)
Front Nut
Plate
Bolt Plate
(short)
Driver Side Hardware Passenger Side Hardware