Monoprice 8088 Wireless HDMI Extender with Matrix and IR Receiver Kit - Manual (Page 15)

Wireless HD AV Transmitter & Receiver Kit
14
7. Using Wireless HD AV Kit
The Wireless HD Transmitter & Receiver Kit has now been setup. You can enjoy the full potential of
wireless Full HD streaming!
Make sure all devices have been started. Bear in mind that starting the Transmitter & Receiver Kit
can take up to 12 minutes.
Use enclosed remote control to select the video source from HD IN 1 to HD IN 4 to display on
Display A. You can also use the remote control to select the video source for showing on Display B.
Please make sure you have chosen the right video channel on your display device. If correct, the
screen or main menu of the media device will be shown between 5 to 10 seconds when change
media source.
You can control the media device with its original remote control at the Receiver side.
8. FAQ
Q: How to reset the device?
A: Shut down the Transmitter and Receiver units by slide the power switch to OFF. Wait for a few
second and slide the power switch’s to ON again.
Q: Why I cannot control my media device at the Receiver side?
A: Please check the Transmitter side. If you are not using the switch, please make sure the Infrared
Eye Cable is connected with the IR port and the IR flasher is placed close to your media device’s IR
receiver. If you are using the HDMI switch, please check the connection between the IR Extender
Box and the switch. Please also check the connection between the IR Extender Box and your
media devices. Make sure the IR flashers are placed close to your media devices’ IR receivers.