AT&T Cordless Telephone MLC-6 User Manual
Page 20
![background image](/manuals/40654/20/background.png)
Programming Channels (More
Than One Cordless Phone)
Channels 0-9 are available to MLC-6 cordless phones. If you use
more than one cordless phone, you should program each one to
operate on different channels to avoid channel interference.
To program channels:
1.
2.
3.
4.
Verify that the antennas on the base and handset are fully
extended.
While the handset is turned off, press [ Feat ] and then press
the Channel button.
CH C appears on the display to indicate that the phone is in channel
program mode and ON flashes on the display.
Use the numeric dialpad keys to enter a digit for each channel
(0-9) to be allocated to the handset. For example, if you have
two MLC-6 cordless phones, assign channels 0-4 to the first
phone and channels 5-9 to the second.
CH C disappears from the display and is replaced by whatever digit
you enter. Wait for the digit to appear before entering the next one.
When you are finished, press the Channel button again.
To verify the channels you programmed:
1. Press the Channel button.
The first channel number programmed appears in the display.
2. Press the Channel button again.
If you programmed more than one channel, the second channel
number appears on the display.
3. Continue pressing the Channel button to verify the rest of the
channels programmed.
NOTE:
If you accidentally place a cordless handset in the wrong base,
you will not be able to make or answer calls on the original
handset. To solve the problem, replace each handset in its
correct base for at least 10 seconds.
17