AT&T Cordless Telephone MLC-6 - Manual (Page 14)

Installing the Base
If desk mounting, skip step 1 and steps 3–6.
If wall mounting, remove the Plug one end of the modular
four screws in the bottom of the
base. Turn the bottom of the base
180° as shown above, then screw it
back into place. telephone cord into the jack on the
bottom of the base. Then route it
and the AC power cord along their
respective channels.
Reverse the handset hook. Mark screw locations using
Press the hook down and slide it up
out of its slot, then turn the hook
upside down and replace it in the
slot, with the top protruding so the
handset can hang from it. the Wall Mount Template on the
inside back cover of this booklet.
Choose a location backed by a
wooden stud. (If no wooden stud is
available, use toggle bolts instead
of the wood screws provided.)
11