Flaming River Tri-5 5 Power Rack and Pinion - Manual (Page 11)

Page 10 of 11
55-57 Chevy Rack & Pinion Installation
122809
JJ/RD
Power Rack & Pinion Universal Joint System Con’t
Note: The angle of the support bearing mount is set for most applications. Some adjustment may be necessary for the correct
angle and u-joint alignment
2). We recommend the use of ¾” dowel rod to mock up the steering shaft to obtain the correct length of the shafts. Install your
shaft kit and snug each set screw so that it will leave a mark in the shafts.
3) Remove shaft and dimple each setscrew mark using a ¼” drill bit. (As shown above.) Re-install the shafts using red loc-tite
thread locker
on the set screw threads. Tighten each setscrew to 25 ft. lbs. Tighten all lock nuts securely. We recommend that
you Inspect setscrews periodically for tightness.
Power Steering Pump Installation