Flaming River Camaro Rack & Pinion Cradle Kits 1967-69 - Manual (Page 4)

Installation of Flaming River Column
1) Install the upper portion of the new Flaming River under dash mount
into the stock location. (see photo B)
2) Install rubber isolator into the original floor mount and then slide it over
the column tube. Slightly snug clamp. (see photo A)
3) Place the column under the dash and snug the two mounting screws for
the under dash mount. (see photo B )
4) Install the floor mounting screws and tighten to 15 ft lbs.
5) Ensure that the column straight by having the turn signal arm points to
the 9 o’clock position. Tighten the two mounting screws on the new
Flaming River clamp. ( see photo B)
6) Tighten the floor mounting clamp around the tube. (see photo A)
7) Install the wiring jumper harness.
Photo A
Photo B
67-69 Camaro
Power Steering
10/17/2005
3