Flaming River Camaro Rack & Pinion Cradle Kits 1967-69 - Manual (Page 2)

Index
NOTE: Before beginning you must first measure the width of your front end from LEFT outer tie
rod end zerk to the RIGHT outer tie rod end zerk to determine the overall width of your front end.
Write dimension here for further reference
NOTE: Hoses (FR1625) and Pump Mounting Brackets (FR1611) are sold separately and are not
included in this kit.
NOTE: Part number ES381RL 68-69 Camaro Outer Tie Rod Ends must be used
with this rack and pinion kit.
NOTE: 1969 Camaro straight column may require a 1” smooth u-joint.
Section 1 Original System Removal
A. Original Column & Wheel Removal PG 2
B. Steering Box & Linkage Removal PG 2
Section 2 Installation of Flaming River Column
A. Installation of New Flaming River Tilt Column PG 3
B. Electrical System Notes PG 4
C. Steering Wheel Installation PG 5
Section 3 Installation of the Flaming River Rack & Cradle
A. Installation of Rack and Cradle PG 6-
Section 4 Universal Joint Installation
A. Universal Joint and Steering Shaft Installation PG 7
Section 5 Power Steering Pump
A. Installation & Bleeding Procedure PG 8
Torque Specs
PG 8
Section 5 Hardware Package
A. Installation hardware and inventory PG 9
Note: For safety disconnect battery cables and ensure that vehicle is properly supported by jack
stands.
We recommend a professional alignment to set the proper alignment settings after system
installation.
We recommend that you always install new outer tie rod ends when installing this kit.
67-69 Camaro
Power Steering
10/17/2005
1