DAVIS Wheel-a-Weigh: Launching Wheels for Boats, Extra Capacity - Manual

#1481
ASSEMBLY INSTRUCTIONS
This model is not to be used on boats over 300 lbs.
(136 kg).
1. Position the tracks on the boat transom, well apart.
Make certain they are clear of any obstruction. The
tracks should be vertical and set equidistant from
the top and bottom of the transom, usually about one
inch (2.5 cm).
2. Mark the four mounting holes for each track, then drill
through the transom with a 1/4" (6.5 mm) drill. If more
distance is required between the boat transom and
the transom tracks, use 1/4" (6.5 mm) spacers. For
mounting on all metal transoms, it is recommended
that wooden backup blocks be used. Your parts kit
contains a quantity of plastic-wrapped sealing com-
pound, which should be applied between the blocks
and the transom at the bolt holes.
3. Secure transom tracks to transom with 2" bolts, 1/4"
washers and 1/4" nuts (see drawing on back).
4. BE SURE THE MAXIMUM TIRE PRESSURE IS
14 P.S.I. (14 pounds per square inch).
CAUTION: Gas station compressors can easily
overinflate and explode tires. Be careful not to
overinflate.
5. Remove the locknut and stainless steel washer from
the axle bolt, making sure to leave the bushing and
nylon washer on. Place the inflated wheel onto the
axle and bushing with the long hub shaft toward the
strut. Replace the stainless steel washer, add a little
light weight oil to the threads of the bolt, then tighten
the locknut snug against the washer.
6. Attach struts to transom tracks with lockpins.
Note: It is a good idea to secure the four lockpins to
the boat with a short piece of line, since they have a
strong tendency to fall overboard.
CAUTION: This product is not designed to be towed
behind a vehicle. Damage may occur and will void
the warranty.
STORING THE WHEELS
After launching, invert the struts and use the top two lockpin
positions:
Note: You can leave the center lockpin in place and simply
swing the strut up, repositioning only one lockpin.
Removal of both lockpins releases the entire wheel
assembly.
LAUNCHING WHEELS FOR BOATS,
EXTRA CAPACITY
CARRYING THE BOAT
Place lockpins in the bottom two positions of the transom
track: