DAVIS PROP SOX - Manual

INSTRUCTIONS
#450
PROP SOX ® Propeller Covers
Prop Sox are protection for propellers and people. They guard
your expensive propellers from road kickback when towing.
Curious children will be discouraged from spinning your propeller
while the boat is out of the water. People walking by a boat on a
trailer won’t be cut with Prop Sox in place. Prevent rear-end acci-
dents when towing by alerting drivers following too closely.
Prop Sox are made of bright, molded plastic and simply slip over
each propeller blade. The sox are held in place with a rubber
shock cord strap. Set of three socks, strap and 3 reflector hot-dots
included. For use when your boat is out of the water only.
Patented.
Installs in Seconds:
1. Put rubber cinch strap over the
hub of the propeller and slip blade
covers onto propeller blades with
each reflective dot facing out.
2. Secure blade covers with the
rubber cinch strap stretched onto
all three locking tabs. This holds
the blade covers securely together
for trailering.
3. The propeller is now protected
and the sharp edges are covered,
reducing the chance of injury from
curious children or people running
into the exposed blades.
Never operate the motor with Prop Sox in place.
3465 Diablo Ave., Hayward, CA 94545 U.S.A.
Phone (510) 732-9229 • Fax (510) 732-9188
[email protected] www.davisnet.com
August 2005