Aussie VANTAGE 6122S8X641 - Manual (Page 11)

11
To reduce the risk of a laceration hazard, wear protective gloves when handling parts that have sharp edges.
CAUTION
!
Step 7
Heat Shield Assembly
Attach the Heat Shield and the Front Side Table Support to the top of the Front U-Leg with 2) 1/4-20 x 1.5” Bolts. Insert
the bolts through the Heat Shield then the U-Leg then into the threaded inserts in the Front Side Table Support.
Front
Side Table
Support
Heat Shield
(under leg)
1/4-20 x 1.50” Bolt
2 pcs
M4 x .31” Bolt
4 pcs
Step 8
Manifold and Piezo Igniter Assembly
NOTE: Regulator hose is shipped attached to the Manifold.
A. Insert valve stems out through front of the Control Panel so that the holes in the valve brackets align with the holes
in the Control Panel. Fasten in place with 4) M4 x .31” Bolts through the Control Panel into the valve brackets. The
Regulator hose will be on the LEFT side.
B. Install the Piezo Igniter by first, removing the large nut shipped threaded in place on the igniter, then inserting the
igniter through the large hole on the left side of the Control Panel and fastening in place with the large nut previously
removed.
Piezo Igniter
A
B
Large Nut
Model 6122 with
side burner valve
Model 6112 without
side burner valve