DAVIS CABLE BUDDY - Manual (Page 3)

OILING THE CABLE
Remove Cable Buddy's nylon plug. Screw the oiling
tube assembly into the plug hole. Firmly screw the other
end of the oil tube assembly to the oil bottle. Turn bottle
upside down and squeeze firmly while the steering
wheel (or motor) is slowly turned at least three times to
the full extent right and left. This should consume at
least half of the oil in the full bottle. If not, repeat until
half the oil is delivered. Reinstall nylon plug. Some oil
leakage is normal at this point. Under most circum-
stances the oil coating should now extend down the first
18" (56 cm) or so of the inner cable. Oiling should be
repeated once or twice annually, depending on the envi-
ronment in which the motor is used.
00420.151 Rev. B September 2010
3465 Diablo Avenue, Hayward, CA 94545, U.S.A.
Phone (510) 732-9229 • Fax (510) 732-9188
[email protected] • www.davisnet.com
Uilenkade 12 • NL-3336 LP Zwijndrecht • The Netherlands
Phone +31 78 6194316 • Fax +31 78 6192689
[email protected] www.davisnet.com
Replacement Parts
Contact your dealer or Davis Instruments for replacement parts.
R420A Nylon Plug and Oiling Tube Assembly
422 Max-Lube™ Extreme Service Lubricant, 3 fl. oz. (90 mL)