Allied Telesis SB251-13 User Manual
Page 8
8
Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
Hardware filters using classifiers that specified IP addresses were not
accepted by the ADD SWITCH HWFILTER command when added in a
particular order. This issue has been resolved.
If either the MCLIMIT or BCLIMIT parameter in the SET VLAN MCLIMIT
BCLIMIT command was set to NONE, the other parameter was sometimes
incorrectly set to NONE as well. This issue has been resolved.
OSPF sometimes chose routes with an infinite metric over routes with a
finite metric when selecting the best local route. This issue has been
resolved.
When browsing the ifInNUcastPkt MIB counter, the value was not correctly
incremented because only broadcast packets were counted. This issue has
been resolved.
A fatal error sometimes occurred when an IPv6 ping packet length
exceeded 1453 bytes. This issue has been resolved.
A fatal error occurred when the PIM path was recovering. This issue has
been resolved.
MLD startup query packets were not being sent correctly due to IPv6 MLD
being unaware of the IPv6 interfaces it was running on. This issue has been
resolved.
When some DHCP entries were in Reclaim mode, and all interface links
related to the range of these entries went down, these DHCP entries were
stuck in Reclaim mode. This issue has been resolved.
An STP blocking port did not discard SNAP encapsulated packets with
TYPE=00BB (ESRP packets). This caused a loop in the network. This issue
has been resolved.
The GUI install file was not copied to the slave controller card after
executing the SET INSTALL=GUI command. This issue has been resolved.
PCR: 03834
Module: SWCX
Level: 2
PCR: 03835
Module: VLAN
Level: 3
PCR: 03836
Module: OSPF
Level: 2
PCR: 03837
Module: VLAN
Level: 3
PCR: 03839
Module: IPV6
Level: 2
PCR: 03841
Module: IPG
Level: 2
PCR: 03842
Module: IPG
Level: 3
PCR: 03843
Module: DHCP
Level: 2
PCR: 03846
Module: SWCX
Level: 2
PCR: 03849
Module: SYSR
Level: 2
PCR: 03850
Module: FFS
Level: 3