Allied Telesis SB251-13 - Manual (Page 45)

Patch SB251-13 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches 45
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
PIM Graft and Graft-Ack counters were not incrementing. This issue has
been resolved.
PIM-SM Null register messages for non-PIM-SM domain sources did not
have the Border bit set. This issue has been resolved.
The IPMTU parameter in the ADD DHCP POLICY command was
accepting values in the range 0-4294967295. This parameter now accepts
values in the correct range of 579-65535.
An invalid message appeared when the PORT parameter was specified for
the ADD IP ROUTE command. This issue has been resolved.
The source IP address in a PIM Register message was not the DR interface’s
IP address. This issue has been resolved.
Secure mode was being disabled after a re-boot. Secure mode should only
be disabled by executing the DISABLE SYSTEM SECURITY command. This
issue has been resolved.
A fatal error sometimes occurred when forwarding traffic over an IPv6
tunnel. This issue has been resolved.
The SMTP proxy did not correctly allow outgoing (private to public) SMTP
sessions when the DIRECTION parameter was set to OUT or BOTH in the
ADD FIREWALL PROXY command. This issue has been resolved.
The PURGE NTP command did not change the UTC offset to the initialised
RIPng was showing routes to interfaces that were DOWN as being UP. This
issue has been resolved.
The message format for PIM-SM periodic (*,*,RP) Join messages was
incorrect when the message contained more than one joined RP address.
This issue has been resolved.
PCR: 03462 Module: PIM, PIM6 Level: 3
PCR: 03464 Module: PIM, PIM6 Level: 3
PCR: 03465 Module: DHCP Level: 3
PCR: 03467 Module: IPG Level: 3
PCR: 03468 Module: PIM Level: 3
PCR: 03469 Module: CORE Level: 3
PCR: 03471 Module: IPV6 Level: 2
PCR: 03474 Module: FIREWALL Level: 3
PCR: 03475 Module: NTP Level: 3
PCR: 03476 Module: IPV6 Level: 3
PCR: 03478 Module: PIM, PIM6 Level: 3