Allied Telesis SB251-13 - Manual (Page 30)

30 Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
DVMRP unicast Prune, Graft, and Graft-Ack messages are now switched at
Layer 2.
DVRMP messages Prune, Graft and Graft-Ack are now switched at Layer 2.
L2/L3/L4 hashing (used to allocate ports within a trunk group) was
incorrectly formatted. This issue has been resolved.
DHCP policies are no longer stored in alphabetical order in the DYNAMIC
CONFIGURATION script because this did not work when the DHCP
INHERIT parameter was used.
TCP sessions could fail if the public side of the firewall was using Kerberos
and the private side had a very slow connection to the firewall. This issue
has been resolved.
An error sometimes occurred in the firewall module under heavy FTP or
RTSP traffic loads. This issue has been resolved.
The SHOW IP INTERFACE command was showing ETH interfaces as up at
startup, when SHOW INTERFACE and SHOW ETH STATE had them as
down. This issue has been resolved.
The SHOW IPv6 COUNTER command now shows the outAdvert messages
in the Total Out Messages counter field.
DHCP assigned incorrect IP addresses to clients shifting from a relayed to a
non-relayed range. This issue has been resolved.
The SHOW IPV6 INTERFACE command was not displaying the link layer
address and EUI when the interface was down. This issue has been
resolved.
Users with either USER or MANAGER level privilege can now execute the
STOP PING and STOP TRACE commands. Previously, MANAGER
privilege was needed to execute these commands.
The SET IP ROUTE FILTER command was not processing some parameters.
This issue has been resolved.
PCR: 03078 Module: SWI, VLAN Level: 3
PCR: 03091 Module: SWI Level: 4
PCR: 03095 Module: DHCP Level: 2
PCR: 03111 Module: FIREWALL Level: 1
PCR: 03116 Module: FIREWALL Level: 2
PCR: 03120 Module: ETH, IPG Level: 4
PCR: 03124 Module: IPV6 Level: 4
PCR: 03126 Module: DHCP Level: 2
PCR: 03139 Module: IPV6 Level: 3
PCR: 03144 Module: CURE Level: 4
PCR: 03145 Module: IPG Level: 4