Allied Telesis SB251-13 - Manual (Page 65)

Patch SB251-13 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches 65
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
Features in SB251-01
Patch file details are listed in Table 9:
Layer 2 filtering is now working correctly.
32 bit counters now only show 8 bit contents.
The IPM (Layer 3 Multicasting table) now updates correctly to add or delete
the ingress linecard to control blade ports, and the control blade to egress
linecard ports when updating forwarding.
The ENABLE SYSTEM SECURITY_MODE command was enabling the
system security mode, but after the switch was restarted the system security
mode was disabled again. Also, when NVS was re-initialised because, for
example a battery had been exhausted, the system could not make an SNMP
trap. These issues have been resolved.
When the DISABLE SWITCH PORT FLOW=PAUSE command was
executed on a port or ports, they would still appear to be enabled at a higher
level. This issue has been resolved.
DHCP RENEW request messages are now unicast (as defined in the RFC),
not broadcast.
VLAN tagged multicast packets were incorrectly being sent over untagged
VLAN interfaces. This issue has been resolved.
Some change actions, and the resending of prune messages were not
operating correctly. This issue has been resolved.
Table 9: Patch file details for Patch SB251-01.
Base Software Release File sb-251.rez
Patch Release Date 15-Jan-2003
Compressed Patch File Name sb251-01.paz
Compressed Patch File Size 71828 bytes
PCR: 02555 Module: SWI Network affecting: No
PCR: 02561 Module: SWI Network affecting: No
PCR: 02563 Module: SWI Network affecting: No
PCR: 02568 Module: CORE Network affecting: No
PCR: 02576 Module: SWI Network affecting: No
PCR: 02396 Module: DHCP Network affecting: No
PCR: 02575 Module: SWI Network affecting: No
PCR: 02574 Module: DVMRP Network affecting: No
PCR: 02582 Module: SWI Network affecting: No