Turbo Action 70011 CHEETAH SCS Shifter - Manual (Page 5)

Part #70011 5 2/92,9/98,2/01,1/02,6/05,6/06,3/07
1. Install #17018 Switch and #17074 Seal into side of transmission, driver’s side.
2. Install a #14 gauge wire from this switch to the starter relay which is usually located
on the left fender near the battery. Attach wire to spade shown as “G” in drawing.
3. Install a #14 gauge wire from spade marked “I” on starter relay to either the key
switch or a remote start button.
4. The other side of the start button should have a 12V source.
5. Install a #12 gauge wire from post “S” on starter relay to the starter solenoid.
6. Install a wire from the positive battery post of the battery to the post marked “B” on
the starter relay.
7. This neutral safety system works in park, neutral and requires no adjustment.
Park/Neutral Start Kit
Installation Instructions
Park/Neutral Start Switch
#17018
To Starter
G I
S
B
+
-
Starter Relay Key
or
Start Button
To Starter
Solenoid #12 Wire
#6 Wire
Battery
Cable
#14 Wire
Chassis Ground or Motor
12 Volt
Battery
T
#10-#12 Wire