Turbo Action 36156 Ford C6 1966-76 Street Manual/Automatic Valve Body (PRND21) - Manual (Page 2)

Part #36155/#36156 2 4/76,8/99
STEP #7: Start all bolts (Note two long bolts go through filter). Tighten all bolts down being sure that
the shift lever and passing gear linkage are working properly. Bolts should be tightened to
8-10 ft./lbs.
STEP #8: Clean pan and install new Pan Gasket #36127. Replace pan on transmission and tighten all
bolts securely.
STEP #9: Adjust intermediate band located on driver’s side near shift lever. Take a 13/16” box wrench
and break locknut loose. Now holding locknut from turning, take a small 3/8” open end
wrench and turn square adjustment lug clockwise until wrench feels snug (10 in./lbs.).
CAREFULLY back off (CCW) one full turn only. Holding the adjustment lug, tighten locknut
to 35 ft./lbs. (tight).
STEP #10: Add four (4) quarts of a good brand of Ford Type “F” or Dexron Mercon transmission fluid.
STEP #11: Start motor and add transmission fluid until dipstick reads approximately one pint low or the
add mark. Please note that C6 transmissions may take as much as a total of eleven (11)
quarts of transmission fluid.
STEP #12: Take vehicle out and drive normally around the block. Now recheck transmission oil level.
Add oil if necessary, but DO NOT OVERFILL!