Sper Scientific 840052 Data Acquisition Software - Manual (Page 22)

Total 6 or 7 parameters could be displayed on the monitor:
Velocity, Temperature, RH, DP, WET, VOL & BTU (or no BTU)
The meter unit can be easily changed at your disposal, if the meter
o o unit sets in C , the data logging value is shown with C. Once you
o o change the meter unit to F, the screen unit will be changed to F
simultaneouly.
ANEMO-PSYCHROMETER
Recommend to reset the Display Control at the same time, or you
will see a minor chart change on the screen. (See Diagram X )
The same condition applied to change the unit between FPM and
MPS .
FORMAT:
Baud Rate :9,600 bit /sec.
Data Bits : 8
Stop Bit : 1
VXXX.XMPS(FTM):TXXX.XC(F):HXX.X%:dXXX.XC(F)
:wXXX.XC(F):vXXXXX.XCMM(CFM):UXXXXX.XKW(BTU)
NOTE: Last parameter is depended on different type of meter.
If the Velocity ( V) is in the left block, the right block will be others.
20
Diagram X