Sper Scientific 850034K AquaShock® Water Purity Kit - Manual (Page 9)

9
SETUP MODE
The Setup Mode allows you to customize the following meter
preferences and defaults:
• Temperature Scale
• Clock Setting
• Restore Factory Defaults
• Set ATC Temperature Coefficient
• Set TDS Factor
1. Press POWER to turn the meter on before performing any
setup function.
Temperature Units
1. Press SETUP to enter the Setup Mode.
2. Press SETUP to enter the Set Temperature screen.
3. The unit °C or °F will flash on the LCD.
4. Press ↑ or ↓ to select the °C or °F temperature unit.
5. Press SETUP to save and return to Normal Mode.
6. Press EXIT to return to Normal Mode without saving the selection.
Note…
When the temperature reading is outside the range, the display will
show “HHH” (high) or “LLL” (low).
Real Time Clock
1. Press SETUP to enter the Setup Mode.
2. Press ↑ or ↓ to select the Set Clock screen (see Fig. A).
3. Press SETUP to set the year (see Fig. B). The value will flash
on the LCD.
4. Press ↑ to increase the value by 1. Hold down ↑
to continually increase the value.
Press
↓ to decrease the value by 1. Hold down ↓
to continually decrease the value.