Sper Scientific 850034K AquaShock® Water Purity Kit - Manual (Page 16)

17
View Calibration Points
1. Press RANGE to choose the scale you wish to view.
2. Press SETUP to enter the Setup Mode.
3. Press ↑ or ↓ to select the View Cal Data screen (see Fig. A).
4. Press SETUP to enter the View Cal Data Mode. The date
and time is a cyclic display (the Conductivity scale will
display as in Fig. B and Fig. C. The TDS scale will display
as in Fig. D and Fig. E). If there are no calibration points
set the display will show “- - - -” (see Fig. F).
5. Press ↑ to view the previous Cal point. Repeat to
view all previous Cal points.
Press ↓ to view the next Cal point. Repeat to view
additional Cal points.
6. Press SETUP or EXIT to return to Normal Mode.
Fig. A Fig. B
Fig. C Fig. D
Fig. E Fig. F