Ridetech 11250199 - Manual (Page 3)

11252409 Installation Instructions
1. Raise and support vehicle at a safe, comfortable working height. Let the front suspension hang
freely.
2. Remove the coil spring, shock absorber, upper shock mount, lower coil spring mount, and strut
tower reinforcement plate. Refer to a factory service manual for proper disassembly procedure.
The strut tower reinforcement plate will be reused.
1. Place the upper Shockwave plate
on top of the strut tower. Temporarily
secure the plate with two 5/16” x 1”
bolts, Nylok nuts and a flat washer on
each side.
2. With a 5/16” bit drill the two holes
closest to the engine.
3. Remove the nylocs and hold the
lower plate up to the bottom of the strut
tower and finger tighten the nylocs.
Drop the last two bolts into place then
tighten all four bolts.