Ridetech 11012899 - Manual (Page 2)

Installation Instructions
2. Install the ball joints in the lower
arm pointing down.
3. Bolt the lower StrongArm to the car
using the oem bolts. Note that the
sway bar mount will face toward the
front of the vehicle.
1. Remove factory cross shafts from
lower arm and install the factory cross
shaft onto the lower StrongArm using
the factory hardware. Some grinding
must be done on the cross shaft to be
able to slide it into the StrongArm.
Replacement bushings are provided.
Note: There is a driver and passenger
side lower cross shaft. The extended
length of the shaft should go to the
front of the vehicle.