Ridetech 11053699 - Manual (Page 2)

Installation Instructions
58-64 Impala Driver Side Upper StrongArm – Top View
1. Drop the ball joint down through the
ball joint plate, secure w/ the hardware
supplied.
2. Fasten the upper arm to the frame
using the factory hardware. Reinstall
the current alignment shims, but
vehicle must be realigned. This arm
was designed with an extra 2 degrees
of positive caster allowing the car to be
aligned with up to 4 degrees of positive
caster. (This will vary from car to car.)
3. Insert the ball joint stud through the
spindle and install new castle nut and
cotter pin supplied.