Ridetech 11381499 - Manual (Page 2)

Installation Instructions
1. After removing the factory lower
control arm, clean the bushing mounting
surfaces on the frame and lubricate with
the lithium grease supplied.
2. Fasten the lower arm to the frame
using the factory hardware.
3. Slide the ball joint boot over the stud,
then push the stud down through the
spindle. Secure w/ the new castle nut
and cotter pin supplied.
4. Attach to the air spring & shock to the
lower arm using the hardware supplied w/
those kits.
5. Screw the Zerk fitting into the ball joint
and grease.
Sway bar
Control Arm Tab