Ridetech 11382899 - Manual (Page 2)

Installation Instructions
1. After removing the factory lower
control arm, clean the bushing mounting
surfaces on the frame and lubricate with
Lithium grease.
2. Fasten the lower arm to the frame
using the factory hardware.
3. Slide the ball joint boot over the stud,
then push the stud down through the
spindle. Secure w/ the new castle nut
and cotter pin supplied.
4. Attach to the shock to the lower arm
using the ½” x 3” bolt and aluminum
spacers supplied.
5. Screw the Zerk fitting into the ball joint
and grease.
Sway bar
Control Arm Tab