Ridetech 11391499 - Manual (Page 2)

Installation Instructions
4. Attach to the air spring & shock to
the lower arm using the hardware
supplied w/ those kits.
5. Screw the Zerk fitting into the ball
joint and grease.
6. Lubricate the frame bushings with
Lithium grease.
1. After removing the factory lower
control arm, clean the bushing
mounting surfaces on the frame and
lubricate with Lithium grease.
2. Fasten the lower arm to the frame
using the factory hardware.
3. Slide the ball joint boot over the
stud, then push the stud down through
the spindle. Secure w/ the new castle
nut and cotter pin supplied.