Ridetech 13013699 - Manual (Page 2)

350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
1. Remove factory upper arm.
2. Bolt StrongArm to frame using
factory bolts. (Do not tighten yet.)
3. Slide ball joint boot over ball joint
stud. Push stud through spindle.
Secure w/ the castle nut and cotter
pin supplied. The supplied spacer
may be need to achieve proper
castle nut to cotter pin hole
alignment.
4. Install grease fitting and lubricate
ball joint.
5. Position the suspension at ride
height (about mid travel) and tighten
upper arm bolt.
6. Vehicle may need to be realigned
before driving.