Ridetech 11220702 - Manual (Page 2)

Installation Instructions
1. Attach the upper T-bar to the frame
in the oem location using the supplied
3/8” x 1 ¼” USS bolts, washers and
Nylok nuts.
2. The bottom of the shock attaches
with the new cantilever pin supplied.
See diagram below.
Note: The hole in the axle bracket may
need to be drilled out to 5/8”
1. Cantilever Pin
2. 5/8” SAE Washer
3. Aluminum Bearing Spacer
4. .625” Bearing
5. Aluminum Bearing Spacer
6. Factory axle bracket
7. ½” Lock Washer
8. ½” SAE Nut