Ridetech 11370501 - Manual (Page 2)

Installation Instructions
1. The large hole in the bracket will
align with large hole in the frame.
Using the bracket as a template, drill
the remaining holes in the frame. Use
3/8” x 1 ¼” bolts, Nylok nuts and
washers to secure the bracket. The
inside of the frame can be accessed
from the coil spring pocket to install the
nuts.
Note: This bracket must be mounted
BEFORE installing the air spring.
2. Drill a 5/8” hole in the rear leg of the
lower control arm approximately 8 ½”
from the mounting bolt. This can be
moved slightly to achieve maximum tire
clearance. Check tire clearance lock
to lock. If using Strong Arms there
is a tab for the shock.
3. Attach the shock to the upper mount
as shown in the picture.
4. Push the shock stud through the
lower shock eye and aluminum spacer.
Then through control arm and fasten
with supplied nut.
This picture is shown with the optional
StrongArm installed.