Ridetech 11169100 - Manual (Page 3)

4. Apply lithium grease to the poly
bushing then slide it over the sway
bar.
5. Secure the sway bar to the frame
with two 5/16” x 1” Socket Head Cap
Screws, flat washers and Nylok nuts.
Note: Due to the larger diameter
bar, the front hole must be drilled
with a 5/16 bit, in front of the factory
hole. Use the bracket as a template.
6. On some cars clearance of the
cross member may be needed for
sway bar clearance.
.