Ridetech 12109100 - Manual (Page 2)

12109100 Installation Instructions
*****This sway bar is designed to work with our upper StrongArms******
1. Apply lubricant to the poly
bushing, then slide it over the sway
bar.
2. Place the sway bar fame bracket
over the bushing. Bolt the sway bar
to the frame using the 3/8” x 1 ¼”
bolts, Nylok nut and flat washers
supplied.
Note: Do not tighten the frame bolts
until after the PosiLinks are installed.
3. Attach the 90 degree end of the
PosiLink to the rear tab of the upper
control arm using a 10mm Nylok nut
and a 3/8” flat washer on each side
of the tab.
PDF created with pdfFactory trial version www.pdffactory.com