Ridetech 11289000 - Manual (Page 2)

Installation Instuctions
1. Replace the factory panhard bar
with the new one using the new
stud and hardware supplied. The
rubber rod end will be attached to
the axle.
2. The Heim end will attach to the
frame using the 9/16” x 3” bolt and
Nylok nut. Two aluminum T-
bushings need to be installed on
each side of the Heim end.
3. The panhard bar should be
approximately 35 ¾” center eye to
center eye, but may need adjusted
to center the axle. This should be
checked at ride height.