Ridetech 11051100 - Manual (Page 3)

58-64 Chevy Car ARF10600-LCA Installation Instructions
1. Raise and support car at a safe, comfortable working height. Let the front suspension
hang freely
2. Remove coil spring, shock absorber, and lower control arm. Refer to factory service manual for
proper disassembly procedure.
Note: Lower arms will not work with stock 1958 spindles.
3. Position the upper shock mount on the
frame so the hole in the bracket aligns with
the hole in the side of the frame and the
tab is against the bottom of the frame.
You may have to trim some of the inner
fender well for clearance. On manual shift
cars you may have trim the bottom of the
Z-bar clutch bracket on the driver’s side.
4. Mark the hole in the bottom of the
frame and drill with 5/16” bit. Use the 3/8”
self-tapping bolts supplied and bolt the
bracket to the frame. Mark and drill the
remaining holes.
Picture shows alignment hole on side of
frame.