Ridetech 11161099 - Manual (Page 2)

2
Installation Instructions
******Must be used w/ RideTech shock kit******
1. To allow clearance for the air spring,
aportion of the frame on the outside of
the coil spring pocket must be removed.
This is best done with a die grind &
cutoff wheel or plasma cutter. Cut all
corners round and grind all edges
smooth.
Note: It may be helpful to partially install
the air spring assemble to see exactly
what needs cut out.
2. The inner lip of the coil spring pocket
must also be trimmed.
Note: The upper shock mounts must be
installed before install air spring.
Note: To achieve proper sway bar
clearance and the most effective angle,
the sway bar end link spacer must be
shortened to 1.5” long. A shorter bolt is
supplied.