Ridetech 11250500 - Manual (Page 2)

350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Installation Instructions
1. For mounting the lower shock stud
a 5/8” hole must be drilled in the upper
control arm. The inside edge of this
hole will align with the outer edge of
the lower air spring plate.
2. Bolt the stud to the upper arm using
the hardware supplied.
3. Place a washer and bushing on top of the shock stud
then slide it up through the new hole in the strut tower.
One more bushing then washer and nut will hold it in
place.
4. Slide the bottom of the shock onto the stud. There
should be a washer on either side of the bushing.
Fasten with supplied nut.
.