Ridetech 11381099 - Manual (Page 3)

9. Remove original bumpstop and replace with the shorter one supplied. Although, it is OK to let the
suspension bottom out on the air spring.
10. Ride height on this air spring is around 4.5” - 5.5” tall.
IT IS THE FINAL RESPONSIBILITY OF THE CUSTOMER / INSTALLER TO MAKE SURE THAT
THE AIR SPRING DOES NOT RUB ON ANYTHING AT ANYTIME!!
4. Apply thread sealant onto an air fitting and
screw it into the top of the air spring.
5. Place the upper cup bracket on top of the air
spring and secure w/ the 3/8” Nylok nut and flat
washers supplied.
6. Screw the 7/16” all thread into the nut in the
bottom of the cup bracket.
7. Place the assembly into the upper coil spring
pocket w/ the stud sticking through the factory
shock hole. Secure w/ a 7/16” Nylok nut and flat
washer.
8. Fasten the air spring to the lower arm using a
3/8” x 3/4 bolt, flat washer and lock washer.