Ridetech 12134099 - Manual (Page 3)

7. Place the lower air spring bracket over
the coil spring retainer on the lower arm.
8. Use another retaining plate along with
a 3/8” x 1 ½” to attach the air spring to the
lower control arm.
12. On 79-93 Models a hole must be cut
in the inner fender well to access the top
of the pocket to attach the air spring to the
car. 11. On 79-93 Models the body must be
trimmed to ensure that it does not rub the
air spring.
9. Double check air spring clearance
through full suspension travel. Allowing
the air spring to rub will cause failure
and is not a warrantable situation. Pay
special attention to the brake line to air
spring clearance.
10. Ride height on this air spring is
approximately 5” tall, this may vary to
driver preference.