Ridetech 11446799 - Manual (Page 6)

13. The installation is now basically complete. Check for axle clearance to the bed and to the
bumpstops. Pay particular attention to the brakeline junction block on top of the axle housing.
You can now run the airlines and continue with the compressor kit installation. Inflate to approx. 25psi
to begin tuning the air ride system. You will probably find 20 to 25psi appropriate for an unloaded
truck. Try to maintain at least 3” of clearance between the axle and bumpstop to maintain a civilized
ride quality. When you load the vehicle, increase the air pressure as needed to support the extra
weight and to maintain this clearance.
12. Install the spacer block under the
carrier bearing to correct the driveshaft
angles.