JELD-WEN JII110 Interior Door Slabs - Manual (Page 4)

4
©2014 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual
property laws. All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others.
Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specifications without notice. Please check our website, jeld-wen.com, for current information.
INSTALLATION INSTRUCTIONS
for Interior Door Slabs (JII110)
CoMPLeTe InsTaLLaTIon
4
Lockset
hole
Rail
Panel
Latch
hole
2 3/8"
(02/14)
Please visit jeld-wen.com for finishing instructions, warranty and care and maintenance information.
Thank you for choosing
INsTALL LoCksET AND FINIsH INsTALLATIoN
1. The center of the
hole for the lockset
is usually 44" from
the top of the slab
and either 2 3/8" or 2
3/4" on center from
the edge, depending
on the latch. For
slabs that have
a rail (horizontal
member) across the
center of the slab,
the lockset should
be centered in this
rail. Using the lockset
manufacturer's
instructions and template, drill for lockset. generally, a 2 1/8"
diameter hole is needed for the lockset. Drill a 1" latch hole through
the edge of the slab into the center of the lock hole to accommodate
the latch for the lock. Some latches have a radius (rounded corners)
or rectangular face plate that will require the slab edge to be
chiseled for fit. drill pilot holes for attachment screws. other latches
are round (contractor drive-in) and can be tapped into place with a
hammer.
2. Close slab and check for proper operation. Adjust as necessary.
3. Finish all surfaces of the slab if not already done.
4. If installing a solid
core, custom carved,
or stile and rail slab,
install a #9 x 2 1/2"
screw in the center
hole (as shown) in
the top two hinges
(through the leaves
toward the jamb).
Jamb
Replace with
longer screw