JELD-WEN JII105 Swinging French and Patio Doors - Manual (Page 8)

INSTALLATION INSTRUCTIONS
for Swinging French and Patio Doors (JII105)
8
2. Mark where active
screen securing
hardware should
be mounted and
apply strike plate.
Door frame must be
pre-drilled to accept
screws.
3. Position larger active
screen on the outer
track at the top and
bottom.
4. Using a #2 Phillips
screwdriver, adjust
outer screen rollers
at top and bottom
until screen slides
properly. Turning
the screws counter
clockwise retracts
the rollers into the
frame.
5. Adjust the wheels at
both the top and bottom in order to center the screen between the
head and the sill.
Note! Excessive tension may cause binding. Adjust so the top and
bottom are parallel with the head and sill.
For Patio Doors:
1. Position screen on
the screen track at
the top and bottom.
For Both Doors:
1. Trim bug flap on
screens to desired
length. Adjust the
upper and lower
adjustment screws
to ensure smooth
screen operation.
Screen track
Outer screen track
INSTALL DRIP CAP
1. Install drip
cap above the
brickmould header
trim.
2. Cut a piece of drip
cap the length of
the header trim +
1/8" to allow for
1/16" overlap on
each end of the
trim.
3. Apply 1/4" bead of
sealant to header trim as shown.
4. Nail drip cap in place as shown.
5. Apply sealant underneath the drip cap where it meets both ends of
the trim.
Screen
Mark here
Frame
8
INSTAll SCReeN SySTeM - CONTINUeD
9
COMPleTe INSTAllATION
1. Apply sealant along
both sides and top
of the door unit
where the exterior
trim rests against
the outside of the
house and where
the brickmould
meets the jambs.
Finishing
-
-
Interior sheeting
Sealant
Sealant
Brickmould
Wall exterior
Jamb
Sealant locations Shown From Top
Sealant