EOTech Holographic Hybrid Sight I EXPS3-4 with G33.STS Magnifier User Manual
Page 25

elevation and windage, each click will change the bullet’s point of impact 1/2 Minute of Angle (MOA),
¼ inch (6.35mm) at 50 yards (45.7m), or ½ inch (12.7mm) at 100 yards (91m). Also, one full rotation of
either knob will change the point of impact 10 MOA, 5 inches (127mm) at 50 yards (45.7m), or 10
inches (254mm) at 100 yards (91m). To move the point of impact UP, turn the elevation adjustment
LEFT. To move the point of impact RIGHT, turn the windage adjustment RIGHT.
The HWS® elevation and windage adjustments are factory collimated with the bore of the rifle parallel
to the mounting rail. The sight should be close to mechanical zero when mounted on a properly
installed rail. Do not turn the adjustments before mounting the sight on the firearm. Be sure to check
that the mount and sight are securely mounted after initial firing
CAUTION – When encountering an increase in resistance in adjustments, the end of the adjustment
range has been reached. DO NOT turn the adjustments any farther, serious damage may occur to the
sight.
17
- EXPS3 EXPS3 Holographic Weapon Sight (Black, Ring/Double Dot Reticle) Model EXPS2 Holographic Weapon Sight (Red Circle-Dot Reticle) Model EXPS2 Holographic Weapon Sight (Green Circle-Dot Reticle) Model XPS2 Holographic Weapon Sight (Ring with Single Red Dot Reticle, Gray) XPS2-Z XPS3 XPS2 300 Blackout Holographic Hybrid Sight II EXPS2-2 with G33.STS Magnifier EXPS2