Airlink101 AR660W3G - Manual (Page 67)

68
After you clicked Apply, the following message will be displayed on your web browser:
You can click “Continue” to back to previous setup page to continue on other setup procedures,
or click “Apply” to reboot the router so the settings will take effect (Please wait for about 30
seconds while router is rebooting).
3.6.3 Remote Management
Enable the remote management so an authorized user can configure the Router from a remote site with
its WAN IP address. You can specify a port for the remote management.
Parameters
Description
Host Address
Input the IP address of the remote host you wish to initiate a
management access.
Port You can define the port number this router should expect an incoming
request. If you
‟re providing a web service (default port number is 80),
you should try to use other port number. You can use the default port
setting “8080”, or something like “32245” or “1429”. (Any integer between
1 and 65534)
Enabled
Select the field to start the configuration
After you finish with all settings, please click “Apply” button.