AirSep MN136-1 H - Manual (Page 17)

[Read the Important Safety Rules section before operating this equipment.]
14 MN136-1 rev H
4.0 Care and Cleaning
Disconnect the power cord from the electrical outlet before you clean
the unit to prevent accidental electrical shock hazards. Only your
Equipment Provider or a qualified service technician should remove the
covers or service the unit.
Do not use liquid directly on the unit. A list of undesirable chemical
agents includes but is not limited to the following: alcohol and alcohol-
based products, concentrated chlorine-based products (ethylene
chloride), and oil-based products (Pine-Sol®, Lestoil®). These are NOT
to be used to clean the plastic housing on the unit, as they can damage
the unit’s plastic.
Clean the cabinet, control panel, and power cord only with a mild
household cleaner applied with a damp cloth or sponge, and then wipe
all surfaces dry. Do not allow any liquid to get inside the device.
Replace the disposable cannula periodically following normal usage
according to your Equipment Providers recommendations.
To prevent a voided AirSep warranty, follow all manufacturers’
instructions.
AirSep does not recommend the sterilization of this equipment.
4.1
Humidifier Bottle (optional)
•
Check water level daily and add water as needed
•
To clean and disinfect the humidifier, follow your Equipment Provider’s
instructions, or the instructions included with the humidifier bottle.
4.2 Outside Cabinet
Use a mild household cleaner applied with a damp cloth or sponge to clean the
exterior of the concentrator, and then wipe all surfaces dry. Do not allow any
liquid to get inside the device.