AirSep MN169-1 - Manual (Page 19)

1. Make sure your power supply is securely connected to the FreeStyle
inlet, as shown in Figure 2.
2. Connect the correct DC power cord end to the inlet marked
ACCESSORY DC IN on the power supply, as shown in Figure 5.
3. Start your motor vehicle.
4. Connect the DC power cord to the motor vehicle’s DC socket, as
shown in Figure 6.
5. To operate the POC, press the FreeStyle [1], [2], or [3] setting on the
unit’s top panel, as determined by your prescription. To turn the unit
off, press the setting associated with the LED illuminated above it.
Use with DC Power (Automobile, Motorboat, etc.)
Figure 5 Figure 6
Caution: When using FreeStyle with the universal power supply in an automobile,
boat, or other motor vehicle, make sure that the vehicle is started and running
before turning on and operating the FreeStyle unit. If the power supply indicator
light does not illuminate and requires resetting, disconnect the power supply
from the motor vehicle’s DC socket, restart your vehicle, and then reconnect
your power supply into the DC socket.
AirSep ® Corporation FreeStyle ™ Universal Power Supply
www.airsep.com Instructions for Use
3-GB
MN169-1 Rev. - 06/10