Asus NCLV-D - Manual (Page 23)

A S U S N C L V - D S e r i e s A S U S N C L V - D S e r i e s A S U S N C L V - D S e r i e s A S U S N C L V - D S e r i e s A S U S N C L V - D S e r i e s 2 - 3 2 - 3 2 - 3 2 - 3 2 - 3
2.2.3 2.2.3 2.2.3 2.2.3 2.2.3 CPU heatsink weight support CPU heatsink weight support CPU heatsink weight support CPU heatsink weight support CPU heatsink weight support
For additional protection from motherboard breakage due to the weight of
the CPU heatsinks, your motherboard package comes with two solution
kits:
• X-PAD accessory kit containing:
- 2 x metal support plates
- 1 x contour sheet
- 3 different sets of metal nuts and rubber pads for varied chassis
standoffs (each set contains 8 metal nuts and 2 rubber pads)
• 2 x CEK spring
You can use any of the two solutions to protect the motherboard.
Using the X-PAD accessory kit Using the X-PAD accessory kit Using the X-PAD accessory kit Using the X-PAD accessory kit Using the X-PAD accessory kit
To install the support plates:
1. Open and lay your system chassis
flat on a stable surface, then
place the motherboard standoffs
on the holes as shown.
2. Align the holes of the contour
sheet with the standoffs on the
base of the chassis. Press the
sheet flat making sure that it is
completely affixed to the chassis.
3. Determine the height of the standoffs on your chassis, and select the
appropriate set of metal nuts and rubber pads from your package.
Use a nut size that is slightly lower than the standoffs on your chassis.
S t a n d o f f S t a n d o f f S t a n d o f f S t a n d o f f S t a n d o f f