Asus P5GPL-X User Manual

Page 39

A S U S P 5 G P L - X

1 - 2 7

7 .

U S B 2 . 0 p o r t s 3 a n d 4 .

U S B 2 . 0 p o r t s 3 a n d 4 . These two 4-pin Universal Serial Bus
(USB) ports are available for connecting USB 2.0 devices.

8 .

U S B 2 . 0 p o r t s 1 a n d 2 .

U S B 2 . 0 p o r t s 1 a n d 2 . These two 4-pin Universal Serial Bus
(USB) ports are available for connecting USB 2.0 devices.

9 .

C o a x i a l S / P D I F O u t p o r t .

C o a x i a l S / P D I F O u t p o r t . This port connects an external audio
output device via a coaxial S/PDIF cable.

1 0 .

1 0 . S e r i a l c o n n e c t o r .

S e r i a l c o n n e c t o r .

S e r i a l c o n n e c t o r . This 9-pin COM1 port is for serial devices.

1 1 .

1 1 . P S / 2 k e y b o a r d p o r t ( p u r p l e ) .

P S / 2 k e y b o a r d p o r t ( p u r p l e ) .

P S / 2 k e y b o a r d p o r t ( p u r p l e ) . This port is for a PS/2 keyboard.

1.10.2

1.10.2 Internal connectors

Internal connectors

1 .

P r i m a r y I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E )

P r i m a r y I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E )
This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA
100/66 signal cable has three connectors: a blue connector for the
primary IDE connector on the motherboard, a black connector for an
Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive), and
a gray connector for an Ultra DMA 100/66 IDE master device (hard disk
drive). If you install two hard disk drives, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer
to the hard disk documentation for the jumper settings.

•

Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.

•

Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

P5GPL-X

P5GPL-X IDE connector

NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.

PRI_IDE

PIN 1