GE 45133 GE Choice Alert Water Leak Sensor User Manual

Page 8

Step 2 – Press the Zone button (1, 2, 3 or 4) for the

Zone you want to assign to the Water Leak Sensor.

The LED indicator for that Zone will begin to flash.
Step 3 –

Release the Zone button.

Note: Zone 4 is for dedicated alerts only. Sensors in this Zone

will not trigger an alarm or chime.

Step 4

- For the Water Leak Sensor, place the

contacts in a small bowl of water, or use a metal

paperclip and touch both contacts.

Erasing the Sensor from a Zone

Note: If you need to remove the Sensor from a Zone, the

system will erase the entire Zone, so any other Sensors will
need to be put back into that particular Zone.

Step 1 - To erase a Zone, press and hold the
Learn button on the Control Center. The unit will

beep once.
Step 2 -

While holding the Learn button, press and

hold the Zone button to be erased. After five

seconds the Control Center will sound two beeps

1 2 3 4

Arm

Zone

Armed Power

Alert

Chime

Off

Mute

Learn

Input DC 12V

Step 1
Press and hold
the Learn button
for three seconds

Step 3
Release the
Zone button
Step 4
Activate the Water
Leak Sensor

Step 2
Select the Zone number