GE 45133 GE Choice Alert Water Leak Sensor User Manual

Page 7

Note: If postioning the probe to a metal surface, ensure the

Probe’s contacts do not touch the metal surface.

Next, stretch the cable

vertically and locate a

suitable position to mount

the transmitter. Follow

the same mounting

instructions above for

mounting the transmitter.
Once the Water Leak Sensor

is mounted, you’ll need to

assign it to a Zone on the

Control Center.

Assigning the Sensor to a Zone
Assigning the Sensor into a Zone is an easy four step
process, however there are a few points to remember
- Only one Sensor can be assigned at a time.
- A Sensor cannot be assigned to two different Zones.
- Up to four Sensors can be added per Zone (if a fifth

Sensor is added then the first Sensor will be replaced.)
- Batteries must be active in the Sensor before it can

be assigned to a Zone.
- Sensors can be assigned to a Zone and then

mounted, or can be mounted and then assign to

a Zone.

Follow these steps to assign a Sensor to a Zone.
Step 1 – Press and hold the Learn button on the

Control Center for three seconds. When the

Control Center sounds a long beep, release the

Learn button.