GE 45133 GE Choice Alert Water Leak Sensor User Manual

Page 10

reinstall batteries. This returns the Control Center
to standard operation mode.

Note: The Control Center will automatically return to standard
operation mode after 5 hours.

Low Battery Indicator
The Control Center continuously monitors all the

Sensors. If the Control Center does not receive a signal

from any Sensor it will begin rapidly flashing the Zone

LED indicator . This indicates one or more Sensors in

the Zone may have low battery power and are unable

to transmit a signal the necessary distance.

If all

batteries and/or Sensors are installed at the same

time into a Zone, it is recommended to replace the

batteries in all Sensors in the Zone.
However, you can check the Water Leak Sensor status

independently by placing the Control Center in Test

mode (see Testing a Sensor on page 9) and trigger

the Sensor separately (i.e. use a metal paper clip and

touch the contacts). If the Sensor does not trigger an
alert then replace the battery with a new one.

Note: The Sensor detection system is ‘range dependant’,
which means Sensors located closer to the Control Center
may seem to have batteries that last longer than those
Sensors at a greater distance. The Lithium cell battery in the
Water Leak Sensor can last up to two years.